NMRV110 10:1: right-angle drive that slows a motor 10 times. With an IEC 132 B5 motor (38 mm shaft) running at 1400 rpm, you get about 140 rpm on a 42 mm hollow output. Stocked in Glen Waverley, Victoria.
Output speed at 10:1
With only 10:1 reduction, most of the motor speed is kept. The worm set runs at its best efficiency here, so it is a good choice for continuous conveyor duty.
With a 4-pole motor (1400 rpm)
about 140 rpm
Output, 6-pole motor
about 96 rpm
Calculated from nominal motor speed; allow a few percent less under full load.
With the same 38 mm input, for less speed, 15:1 gives about 93 rpm. Also in stock: 20:1, 25:1, 30:1, 40:1, 50:1.
Checking it fits your motor
This gearbox expects an IEC 132 motor with a B5 flange: 300 mm flange, 265 mm pitch circle for the four bolts, 230 mm spigot, 38 mm shaft and 10 mm key. All five come from the dimension sheet for size 110.
Motors with feet only (B3) need a B5 flange fitted before they can drive the gearbox.
Different motor? This ratio also comes with 19 mm (IEC 80), 24 mm (IEC 90), 28 mm (IEC 100) input.
About the hollow output
A hollow output lets you mount the gearbox directly on the machine shaft, which saves a coupling. A smear of anti-seize on the shaft makes it much easier to remove later. Solid output shafts are available if you need one.
Gearbox data
Model
NMRV110-10-132
Ratio
10:1
Input
B5 flange, IEC 132
Input bore
38 mm
Hollow output bore
42 mm, 12 mm key
Weight without motor
approx. 41 kg
Flange, bore and weight figures come from the NMRV110 dimension sheet in the photos above.
Good to know
- A worm gearbox can resist turning backwards, but it is not a brake. Any lifting or holding job needs a separate brake.
- Motor wiring must be done by a licensed electrician.
- Line up the driven shaft carefully. A bent or misaligned shaft loads the output bearings and shortens their life.
Postage, returns and warranty
In stock at Glen Waverley, Victoria, and delivered nationwide. Checkout works out the postage; our Returns, Refunds & Warranty Policy covers claims.
Questions about torque or fitting? Call 0401 634 280 or email hankemotors@gmail.com.