100 / 16 mm V pulley (outside diameter / bore), double grooves, cast iron. In stock at Glen Waverley, VIC.
Fitting it to your shaft
Bore size is 16 mm. Measure your shaft with calipers; it should read 16 mm. 16 mm is the metric equivalent of 5/8", a common shaft size on imported and older motors. Two locking screws hold it in place on the shaft.
Using it in a belt drive
Two belts spread the load, which helps on drives that start under load or slip on one belt. Cast iron is heavy and hard-wearing, and its weight helps smooth out the drive.
Speed ratio between two pulleys follows their pitch diameters. With this 100 mm pulley as the driver, a larger driven pulley slows the machine and a smaller one speeds it up.
Need a different diameter for a 16 mm shaft? Try 50 mm single, 50 mm double, 70 mm single, 70 mm double, 90 mm single, 90 mm double, 100 mm single, 120 mm single.
Details
Diameter
100 mm
Shaft bore
16 mm (5/8")
Construction
Cast iron
Belt grooves
2 (double)
Safety and fitting
- Never fit or adjust a pulley with power available to the motor.
- Check pulley alignment with a straight edge across both faces.
- Do not over-tighten the belt; it loads the motor bearings.
- Fit a belt guard before running.
Delivery and warranty
Freight is worked out at checkout and the pulley leaves from Glen Waverley, VIC. See the Returns, Refunds & Warranty Policy for warranty.
Ring 0401 634 280 or email hankemotors@gmail.com with the shaft size and the job.