VT500L: a 500 litre vertical receiver for screw compressor installations. Design code GB150-2011 / AS 1210-2010, 1050 kPa (150 psi) design pressure, 1502 kPa hydrostatic test. Rp2 inlet and outlet. 187 kg. Dispatched from Glen Waverley, VIC.
Made for screw compressor rooms
A screw compressor should load and unload in long, even cycles. With too little storage it short-cycles, which wastes power and wears the airend. At 500 L, the VT500L gives a mid-size screw machine enough buffer to settle into a steady rhythm. The 2-inch inlet and outlet keep pressure drop low at the higher flow rates these machines deliver.
The photos show it fitted with a pressure gauge on the side, a spring safety valve on top and a lever ball valve on the bottom drain.
From the manufacturing data sheet
Internal volume
500 L
Design pressure
1050 kPa
Hydrostatic test
1502 kPa, 30 min
Shell
600 mm × 1500 mm
Wall / ends
5.5 mm / 4.08 mm Q235B
Class / hazard level
3 / B
Inlet · outlet
Rp2 · Rp2
Drain · safety valve · gauge
Rp3/4 · Rp3/4 · M12×1.5
Weight
187 kg
Nozzle and flange material: 20 steel, ANSI #150. Corrosion allowance 0.75 mm. Mounted on a single welded foot frame.
Commissioning checklist
- Confirm the compressor's maximum pressure is below 1050 kPa and the safety valve is set to suit.
- Anchor the foot frame to the floor before you pressurise the tank.
- Pipe the drain to a condensate separator rather than onto the floor. Compressor condensate contains oil.
- Book periodic inspections as your state's WHS regulations require.
Completing the system
Put a refrigerated dryer downstream of the receiver so the dryer gets cooler air and works less hard. If 500 L is more than you need, the VT300L is built the same way. Compressors to suit are in the rotary screw range.
Shipping
Shipped Australia-wide from Glen Waverley, VIC. Freight is calculated at checkout from your postcode and delivery address.
Planning a compressor room? Call 0401 634 280 or email hankemotors@gmail.com and we'll help you match the receiver, dryer and compressor.
Where it is used
Typical applications are screw compressor installations of around 7.5–15 kW that need storage between the compressor and the dryer.
Other receivers: 300 L vertical, 980 L vertical and 500 L horizontal.
Ask us about warranty terms.