VT300L air receiver: a 300 litre vertical tank built to GB150-2011 and AS 1210-2010, design pressure 1050 kPa (150 psi), hydrostatically tested at 1502 kPa. Pictured with a pressure gauge, safety valve and ball-valve drain. Weight 126 kg. Ships from Glen Waverley, VIC.
Built and tested to a documented standard
The manufacturing data sheet for this tank is in the product photos, so you can check it before you buy. The main points:
- Simple pressure vessel, design code GB150-2011 and AS 1210-2010 (Amdt 2), class 3, hazard level B
- Shell 550 mm diameter × 1030 mm long, 5.4 mm Q235B steel, semi-ellipsoidal ends
- Hydrostatic test at 1502 kPa held for 30 minutes
- Single welded foot frame at the base for bolting down
Specifications
Model
VT300L
Volume
300 L
Design pressure
1050 kPa / 150 psi
Test pressure
1502 kPa
Inlet / outlet
Rp2 / Rp2
Drain / safety valve port
Rp3/4 / Rp3/4
Gauge port
M12 × 1.5
Weight
126 kg
Port sizes and shell details are from the manufacturing data sheet in the photos. Rp is a parallel BSP internal thread; use matching BSP fittings.
Where it fits in your air system
Rotary screw compressors work best with a receiver that lets them run in long, steady cycles. Put the VT300L straight after the compressor: air comes in through the inlet, cools, drops its water to the drain at the bottom, and leaves through the outlet to your dryer and filters. The usual order is:
Compressor → receiver → refrigerated dryer → filters → air line
For a larger plant, the VT500L is the same design in 500 L with a 600 mm shell. For the smallest setups there is the VT150L.
Safe operation
- Never run the compressor above the 1050 kPa design pressure. Check the safety valve setting before first use.
- Open the ball-valve drain daily to clear condensate. Water left in the tank corrodes the shell from the inside.
- Do not weld, drill or modify the vessel. Any change voids its design approval.
- Arrange periodic inspection in line with your state's work health and safety requirements.
Shipping
The tank is dispatched from Glen Waverley, VIC, and delivered Australia-wide. Enter your address at checkout to see the freight cost.
Need the data sheet as a PDF, or a tank at a higher pressure rating? Call 0401 634 280 or email hankemotors@gmail.com.