VT150L is our smallest stand-alone air receiver: 150 litres, 1235 kPa design pressure, 390 mm across and 1,700 mm tall, 68 kg. Use it as an extra tank beside a small compressor, or as a second receiver at the far end of a long air line. Ships from Glen Waverley, VIC.
Two common ways to use a 150 L tank
Extra storage for a small compressor
Piston compressors with 50 to 100 L tanks cycle hard once you run a sander or spray gun for long. Adding 150 L next to the compressor gives longer run and rest periods, so the pump runs cooler.
Point-of-use receiver
Put it near a machine that takes big gulps of air, such as a tyre changer or a press, at the end of a long pipe run. The tool draws from the local tank, so pressure doesn't drop across the whole line.
Key figures
Model
VT150L
Volume
150 L
Design pressure
1235 kPa
Temperature range
0 °C to 100 °C
Height × diameter
1700 × 390 mm
Weight
68 kg
Port positions and thread sizes are on the dimension drawing in the product photos. Email us if you need them confirmed before ordering fittings.
Keep it safe
- Protect the tank with a relief valve set at or below 1235 kPa. That is higher than most workshop compressors reach, but the valve is still required.
- Fix the three legs to the floor. A tall, narrow tank tips easily.
- Drain it daily. Small tanks fill with water faster than you'd expect in humid weather.
Need more volume?
Step up to the VT300L or the VT500L. If you are replacing a small compressor altogether, see our piston compressors.
Delivery
Sent from Glen Waverley, VIC, to anywhere in Australia. The freight cost appears at checkout once you have entered your address.
Ask us anything about this tank: 0401 634 280 or hankemotors@gmail.com.
Where it is used
Typical applications are small screw compressors and large piston units that need extra storage, or a secondary tank at the far end of a long air line.
Larger receivers: 300 L vertical and 500 L vertical.
Ask us about warranty terms.