10:1 worm gear reducer, NMRV075, for flange-mounting a 28 mm shaft IEC 112 motor. Expect around 140 rpm at the output with a standard 1400 rpm motor and a 28 mm hollow bore to fit your driven shaft. Ships from our Glen Waverley warehouse.
Is 10:1 the right ratio?
Choose a low ratio such as 10:1 when the driven machine still needs to turn at a fair rate: roller tables, small conveyors, fans driven through a right angle, or a paddle in a tank.
Output, 4-pole motor
about 140 rpm
960 rpm motor in
about 96 rpm
Calculated from nominal motor speed; allow a few percent less under full load.
If 140 rpm is not quite right, 15:1 slows it to about 93 rpm and one step faster is 7.5:1 (about 187 rpm). Also in stock: 20:1, 25:1, 30:1, 40:1, 50:1, 80:1.
Motor fit
Check three numbers on your motor flange: outside diameter 250 mm, bolt circle 215 mm, spigot 180 mm. Those are the IEC 112 B5 figures from the NMRV075 drawing. The shaft goes into a 28 mm bore with an 8 mm key.
A foot-mounted (B3) motor will not bolt on as it is. Fit a matching B5 flange first; we stock B5 and B14 motor flanges by frame size.
NMRV075 10:1 is also listed with 14 mm (IEC 71), 19 mm (IEC 80), 24 mm (IEC 90) input.
Buying a motor as well?
If you do not have a motor yet, our motor and worm gearbox sets come matched, so there is no flange or shaft size to check.
Key figures
Model
NMRV075-10-112
Ratio
10:1
Input
B5 flange, IEC 112
Input bore
28 mm
Hollow output bore
28 mm, 8 mm key
Weight without motor
approx. 9 kg
Flange, bore and weight figures come from the NMRV075 dimension sheet in the photos above.
Good to know
- Do not force the motor shaft in. If it binds, check the key height and clean any burrs off the shaft first.
- Have a licensed electrician connect the motor.
- Line up the driven shaft carefully. A bent or misaligned shaft loads the output bearings and shortens their life.
Shipping and warranty
Freight is worked out at checkout and the gearbox leaves from Glen Waverley, VIC. See the Returns, Refunds & Warranty Policy for warranty.
Not sure about ratio or motor size? Call 0401 634 280 or email hankemotors@gmail.com with the speed you need at the output and what the gearbox is driving.