LC-300/13 vertical air receiver: 300 litres, 13.8 bar design pressure, 550 mm shell standing 1,580 mm tall on three bolt-down feet. Made for compressed air in small workshops and light industrial plants. Shipped from Glen Waverley, VIC.
Why add a 300 L receiver
Most piston compressors come with a tank that is too small for continuous work. The motor starts and stops every minute, the pump runs hot, and the pressure at the tool swings up and down. A separate receiver between the compressor and your air line fixes this:
Fewer motor starts
More stored air means longer gaps between cut-in and cut-out, which is easier on the motor, contactor and pump valves.
Steadier pressure
Short bursts from a blow gun, sander or impact wrench come out of the stored volume instead of pulling the line pressure down.
Drier air
Hot air from the pump cools in the tank and water drops to the bottom, where you drain it off before it reaches your tools.
Specifications
Model
LC-300/13
Capacity
300 L
Design pressure
13.8 bar (1.38 MPa)
Design temperature
5 °C to 100 °C
Shell diameter
550 mm
Overall height
1,580 mm
Mounting
3 feet, bolt-down
Contents
Air / non-harmful gas
Hazard level
B
Shell size, height and temperature range are taken from the design drawing and registration documents shown in the product photos. The design follows GB150-2011 (pressure vessels).
Is 300 L the right size?
A vertical 300 L tank takes up very little floor space, so it suits a workshop corner next to a single compressor. If you run several tools at once or a compressor of 7.5 kW and up, a bigger tank gives you more buffer:
Before you install
- Set the compressor cut-out below 13.8 bar and fit a safety relief valve set no higher than the design pressure.
- Bolt all three feet to a level concrete floor. A tall vertical tank must not be left free-standing.
- Drain the water from the bottom of the tank every day, or fit an automatic drain.
- Pressure vessels need regular inspection. Check what your state's work health and safety rules ask for at your site.
Want drier air than the tank alone can give? A refrigerated air dryer fitted after the receiver removes most of the remaining moisture, which matters for spray painting and CNC machines.
Delivery
Dispatched from our Glen Waverley warehouse to anywhere in Australia. Freight for a tank this size depends on your address and is shown at checkout.
Not sure which tank suits your compressor? Call 0401 634 280 or email hankemotors@gmail.com with your compressor's kW and air output.