NMRV130 10:1 right-angle speed reducer. Divide your motor speed by 10: a 1400 rpm motor gives about 140 rpm, a 960 rpm motor about 96 rpm. Input is a B5 flange for IEC 90 motors (24 mm shaft), 45 mm hollow output. Stocked in Glen Waverley, Victoria.
Is 10:1 the right ratio?
Low reduction (10:1) is mainly about turning the drive through 90 degrees and taking the edge off the motor speed. Think packing-line conveyors, tumblers and rotating screens.
With a 4-pole motor (1400 rpm)
about 140 rpm
960 rpm motor in
about 96 rpm
Output speed = motor speed ÷ 10. Motors slow slightly under load, so the real output will be a little lower.
Close alternatives on NMRV130: 15:1 slows it to about 93 rpm. Full range with this input: 20:1, 25:1, 30:1, 40:1, 50:1, 100:1.
Motor fit
IEC 90 B5 is the interface here. The input flange measures 200 mm with bolts on a 165 mm circle and a 130 mm locating spigot. A 24 mm motor shaft with an 8 mm key slides into the bore.
Have a foot-mount motor? Add a B5 flange for your frame size and it can drive this gearbox.
Other input bores at 10:1: 28 mm (IEC 112), 38 mm (IEC 132).
Fine-tuning the speed
If 140 rpm is close but not exact, run a three-phase motor on a VFD. Lowering the frequency slows the output smoothly without changing gearboxes.
Technical data
Model
NMRV130-10-90
Ratio
10:1
Input
B5 flange, IEC 90
Input bore
24 mm
Hollow output bore
45 mm, 14 mm key
Weight without motor
approx. 59 kg
See the outline dimension sheet in the product photos for mounting-foot and housing dimensions.
Safety and fitting
- Line up the key and slide the motor shaft into the input bore by hand. Never hammer it in; the shock goes straight into the bearings.
- Have a licensed electrician connect the motor.
- Keep the load shaft square to the gearbox; misalignment wears the output seals and bearings.
Delivery
Ships Australia-wide from Glen Waverley, VIC; postage is calculated at checkout. Warranty and returns: see our Returns, Refunds & Warranty Policy.
Send us your motor nameplate and the output speed you are after: 0401 634 280 or hankemotors@gmail.com. We will confirm the right NMRV130 setup.