360 L horizontal receiver: a low, compact tank 1660 mm long and 677 mm high, rated for 14 bar working pressure and tested to 21 bar, designed to EN 286-1. 157 kg empty. Stocked in Glen Waverley, VIC.
A tank that lies down
With its weight sitting close to the floor on a wide welded base, this tank is stable without tall legs. That makes it a good fit for: Typical applications are low compressor rooms, workshops with a mezzanine overhead, and a buffer tank beside a refrigerated dryer.
- low plant rooms, under-bench spaces and areas below mezzanines
- building your own compressor, using the welded pads on the top of the shell (check your pump and motor footprint with us first)
Specification
Volume capacity
360 L
Working pressure (max)
14 bar
Testing pressure
21 bar
Design temperature
10–100 °C
Size (L × W × H)
1660 × 630 × 677 mm
Shell diameter
550 mm
Empty weight
157 kg
Design standard
EN 286-1:1998
Taken from the design drawing in the photos. Hazard level B, corrosion allowance 0.5 mm.
Port sizes
The inlet and outlet are different sizes on this tank, so check them before you buy fittings. Air inlet Rc3/4, air outlet Rc1, drain Rc1/2, safety valve Rc1/2, pressure gauge Rc1/4, and two Rc2 inspection ports at the ends. All ports are female taper thread.
Setting up
- The compressor must cut out below 14 bar. Fit a safety valve to the Rc1/2 port, set no higher than that.
- Level the base so condensate runs to the drain, and empty the drain every day.
- Use flexible hose between a vibrating compressor and the tank, so the vibration doesn't fatigue the threaded ports.
- Your state WHS regulator sets the inspection requirements for pressure vessels. Follow them.
For more capacity in the same low format, choose the 500 L horizontal receiver. Pumps for a tank-mounted build are listed under air compressor pumps.
Getting it to you
The tank goes out from our Glen Waverley warehouse to any address in Australia. You will see the freight price at checkout once your address is in. Ask us about warranty terms.
Building a compressor on this tank? Call 0401 634 280 or email hankemotors@gmail.com.