Replacement start capacitor, 200 µF at 250 VAC. In stock in Victoria.
Where this capacitor goes
Start capacitors are only in circuit during start-up and are built for short bursts. They are found on compressors, saws, mixers and pumps that start under load.
Where it is used
Applications: replacing the start capacitor on a capacitor-start or CSCR motor. Match the 200 uF rating and keep the voltage at 250 VAC or higher; the motor nameplate or the old part shows what is needed.
Replacement checklist
- Copy the capacitance from the old label. A different µF value changes how the motor runs.
- Voltage must be equal to or higher than the original, never lower. This one is rated 250 VAC.
- Keep run with run and start with start.
Nearby values in the same range: 100 µF, 150 µF, 250 µF, 300 µF. See all start capacitors.
Technical data
Rated voltage
250 VAC
Capacitance
200 µF
Supply frequency
50/60 Hz
Before you replace it
- A capacitor can stay charged after power is off. Switch off at the isolator and discharge it safely before handling.
- Take a photo of the wiring first.
- Have a licensed electrician do the work if it involves fixed wiring.
Postage, returns and warranty
Dispatched from Glen Waverley, VIC. Enter your address at checkout for postage. Returns and warranty follow our Returns, Refunds & Warranty Policy.
Email hankemotors@gmail.com a photo of the motor nameplate, or call 0401 634 280.